Magma ROBEN-3PX2 Manual de usuario descargar pdf (Pagina 40)

Magma

Roben 3 | Chapter 2 Hardware Installation

Installation

Expansion Interface Card Installation

By default the Expansion Interface card is already installed for this model. No need to install the Expansion

Interface card. Host Interface card (HIF), is the same exact card as the EIF only that its SW1 switch is set to

“ON=EXP.” The expansion system will NOT function if SW1 is set to OFF=HOST.

If you need to replace or install an Expansion Interface card follow these steps.

1. Turn off the Expansion chassis first. Disconnect the power cord. Disconnect the Thunderbolt cable from

Expansion chassis or from computer

2. Unscrew the Expansion Interface

3. Install new Expansion Interface card

4. Plug-in the card in PCIE slot#0. This is the designated slot for the interface card. Installing the Interface

card in a non-designated slot will cause the system to not operate

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 88 89

Sin comentarios

Magma ROBEN-3PX2 Manual de usuario Pagina 40