Magma ROBEN-3PX2 Manual de usuario descargar pdf (Pagina 33)

Magma

Roben 3 | Chapter 2 Hardware Installation

Install Thermal Pad

Go to page 56 for instructions on how to install Thermal pad.

Connect Cable

1. Connect the thunderbolt cable to thunderbolt port on the back of the unit.

2. Connect the other end of the Thunderbolt cable to Mac mini thunderbolt port.

Plug-in Power Cord

Connect the power cord to the power receptacle on the back of the unit. The Mac mini does not have a Rocker

On/Off switch on the back of the unit.

Powering on and powering off the unit

Roben-3 will automatically turns ON when the computer is turned ON. A White light located on the front panel will

shine when the expansion chassis is ON.

Roben-3 will automatically turn OFF when the computer is turned OFF or goes into Standby mode.

C. Two green LEDs on the Interface card are illuminated.

D. No LEDs are illuminated on the backplane.

Verify Connection

1. You should see four (or Five) Green LEDs illuminated on the interface card and three on the backplane. For

more information on LEDs go to Thunderbolt Interface Card LEDs on page 18 and Backplane LED on page 19.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 88 89

Sin comentarios

Magma ROBEN-3PX2 Manual de usuario Pagina 33