Magma ROBEN-3PX2 Manual de usuario descargar pdf (Pagina 22)

Magma

Roben 3 | Chapter 2 Hardware Installation

Thunderbolt Interface Card Installation

If you need to replace the thunderbolt Interface card follow these steps:

1. Turn off the Expansion chassis first. Disconnect the power cord. Disconnect the Thunderbolt cable from

Expansion chassis or from computer.

2. Unplug the Interface power cable from Thunderbolt Interface card. Unscrew to remove the interface card.

3. Plug-in the Thunderbolt Interface card in PCIE slot#0. This is the designated slot for the interface card.

Installing the Interface card in a non-designated slot will cause the system to malfunction.

4. Plug-in the power cable Thunderbolt Interface card. Secure the interface card.

If you need to install a new Thunderbolt Interface card follow these steps

1. Turn off the Expansion chassis first. Disconnect the power cord. Disconnect the Thunderbolt cable from

Expansion chassis or from computer.

2. Plug-in the Thunderbolt Interface card in PCIE slot#0.

3. Connect the Interface power cable to Thunderbolt Interface card. Secure the interface card.

IMPORTANT

The Roben 3 expansion unit will not power up if the Interface power cable is not attached to

Thunderbolt Interface card or if it is disconnected from the backplane.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 88 89

Sin comentarios

Magma ROBEN-3PX2 Manual de usuario Pagina 22