search

Magma ROBEN-3TM Manual de usuario Pagina 44

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 94
  • Tabla de contenidos
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 43
Magma
Roben 3 | Chapter 2 Hardware Installation
44
Installation
Expansion Interface Card Installation
By default the Expansion Interface card is already installed for this model. No need to install the Expansion
Interface card. Host Interface card (HIF), is the same exact card as the EIF only that its SW1 switch is set to
“ON=EXP.” The expansion system will NOT function if SW1 is set to OFF=HOST.
If you need to replace or install an Expansion Interface card follow these steps.
1. Turn off the Expansion chassis first. Disconnect the power cord. Disconnect the Thunderbolt cable from
Expansion chassis or from computer
2. Unscrew the Expansion Interface
3. Install new Expansion Interface card
4. Plug-in the card in PCIE slot#0. This is the designated slot for the interface card. Installing the Interface
card in a non-designated slot will cause the system to not operate
Vista de pagina 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 93 94

Comentarios a estos manuales

Sin comentarios
  • ConnectPRO Advanced Elements ScoutGuard SMART Modular Unitor
  • BenQ Pantallas Led Q-Logic Aspiradoras Alpine Antenas de televisión Back to Basics Batidoras Bosch Las Llaves De Impacto De Energía
  • Raidon ST2760-2S-S2 Acer P7270i Dell PowerEdge R300 Sony NEX-3NL Electrolux Chest freezers
  • Targus Numeric Keypad Especificaciones Sony PCLK-U5 Manual de usuario AEG FSK93700P Manual de usuario Toshiba Qosmio F60 Manual de usuario Samsung 931BW Manual de usuario