Magma ROBEN-3TM Manual de usuario descargar pdf (Pagina 18)

Magma

Roben 3 | Chapter 2 Hardware Installation

Verify Hardware Connection

Check the status of the LEDs on the Interface cards and backplane to verify good connection or link between your

host computer and expansion unit

1. Thunderbolt™ 1 interface card : 5 solid green LEDS are illuminated and three solid green LEDs on the

backplane. For more details see “Thunderbolt™ 1 Interface Card” below.

2. Thunderbolt™ 2 Interface Card: 7 solid green LEDs are illuminated and 3 solid green LEDs on the

backplane. For more details go to “Thunderbolt™ 2 Interface Card on page 20”.

Thunderbolt™ 1 Interface Card & LEDs

When the Thunderbolt™ 1 Interface card is fully operational and with an external Display device attached, 5 green

LEDs are illuminated (solid green), see FIGURE T1-A .

IMPORTANT

If you are only seeing Two Green LEDs that are illuminated on the Thunderbolt Interface card after

the Magma Roben-3 is turned on, this indicates that there a hardware failure within your expansion

unit. Check your Thunderbolt cable, make sure it is connected firmly and the Thunderbolt Interface

card is seated in the PCIE slot properly.

FIGURE T1-A

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 93 94

Sin comentarios

Magma ROBEN-3TM Manual de usuario Pagina 18