search

Magma PCIHIF68 Manual de usuario Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 60
  • Tabla de contenidos
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
Technical Notes
9
ATTO ExpressPCI UL2S SCSI Controller
ATTO ExpressPro-Tools utility is required to slow down the synchronous transfer rate of the
ATTO ExpressPCI UL2S SCSI controller. At the time of release of this document, version 2.2 of
this software is available for download from ATTO at http://www.attotech.com/software/
T
o download ATTO ExpressPro-Tools utility
1
Starting from the software download page, select “Applications” from the pull down menu.
2
From the Applications page, select ATTO ExpressPro-Tools from the pull down menu.
3
From the second Applications page, select SCSI and Fibre Channel MAC Version 2.2 and click
Next.
4
Enter your name and email address.
NO
TE
If you are not using ATTO RAID software, disable or remove the ExpressPro-Tools Ext 2.2 extension installed
in the Extensions folder within the System folder by the ATTO ExpressPro-Tools Installer. You may otherwise
experience messages at start-up that one or more of your disks cannot be recognized when using RAID
software other than ATTO’s.
To slow down the transfer rate of the ATTO Express PCI UL2S card
1
Launch the ExpressPro-Tools utility.
2
In the Buses and Drives window, if necessary, click the arrow next to the ATTO Technology
Bus so that the arrow points down to display the disk drives on that SCSI Bus.
3
Select one of the several drives listed under the ATTO Technology Bus to highlight the drive.
Do not select the ATTO Technology SCSI controller itself.
4
Choose File>Get Info to open the Device Information window for that drive.
5
Within the SCSI ID Configuration section at the bottom of the Device Information window,
select “20 (10)” from the Synch Rate menu.
6
Click Apply To All at the bottom of the Device Information window.
7
Quit the ExpressPro-Tools utility.
If changes were made, an alert window will appear: “Changes have been made to the Host Bus
Adapter card’s configuration parameters, which will take a few moments to save. Do you want
to save them?”
8
Click Yes.
Once the changes have been written to the flash ROM, an alert appears: “Writing Flash ROM is
complete! You must restart your system for changes to take effect.”
9
Click OK.
10
Restart the computer to effect the changes.
NO
TE
Media 100 recommends that you leave the other settings for the ExpressPCI UL2S SCSI controller at the
defaults.
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Comentarios a estos manuales

Sin comentarios
  • Yukon AdventistSat Prosoft Star Trading CTA
  • Parasound Procesadores Blue Microphones No Code Alarm Alarma de carro ARC Audio Ecualizadores de audio Cisco Gateways / Controladores
  • LG VSF8405SC Pioneer SPH-DA01 Thor Kitchen LRG4801U Step2 Princess Palace Twin Bed Dell PowerVault MD3460
  • Viewsonic Q91B Manual de usuario Makita DP4010 Manual de usuario Asus N43SN Manual de usuario Weber ONE TOUCH Manual de usuario TP-LINK TL-WR700N Guía de instalación